Aftermarket Hiniker Joystick control. This control comes with the correct plug, no adapter required, just Plug-n-Plow. This is the 2 round molded plugs (7 pin & 3 pin) used by Hiniker on the vee blades. In this listing you are just buying the control and the dash mounting bracket. This control has features not offered on the OEM controls. This is for the Hiniker Vee plows with the double acting cylinders (Single acting cylinder control also available on this site).
Size of the box enclosure: 3 1/2″ wide X 4″ deep X 3 1/2″ tall (The handle is 4″ tall)
This control does NOT have a separate headlight switch, but it is set up to switch the headlights automatically when you plug in the control (under the dash). Note: Even if the plow is not attached, the headlights will NOT switch back to the vehicle’s headlights until the control is unplugged (under the dash). If you would prefer a separate switch for the headlights, check out our HINIKER/MEYER 12-PIN HEADLIGHT SWITCH KIT WITH MOUNTING BRACKET.
Instruction sheets: 906 HH-VPP
-Control plugs directly into your existing harness, NO adapter required, just Plug-N-Plow
-Please make sure the connector matches your connector before ordering
-4 way (for Straight Blade Controllers) or 10 way (for Vee & Wing Blades) operation
-U-SET feature allows the user to change some of the controls features.
-Automatic Shut-off when not in use, approximately 22 minutes
-The plow blade will coast to a soft stop (left or right), results in smoother operation and decreased wear on the plows hydraulic system
-Express Up/Down Feature (Double Tap)
-On/Off switch can be used as an Emergency Stop when required
-Illuminated LED on control for night time plowing
-All control functions will time out (shut-off) after a period of time. This helps reduce wear on the pump motor and prevent unnecessary battery drain. Time outs vary depending on which plow the control will be used for.
-Flexible Straight Cord
-Use for both Left or Right Hand
-No Mounting Bracket Included. Although, this control does have a mounting plate on the bottom of the control that accepts four screws (also, NOT Included).
-Instructions come with each control
-Designed and Manufactured in the U.S.A.
DISCLAIMER: The use of the names of manufacturers is for the assistance of our customers in identifying replacement parts which we manufacture or which may be manufactured for 906 Engineering Corp. It is not implied that any part listed is the product of these manufacturers
For Expedited Shipping, please contact us at 906-458-1461. Dismiss