Here is an aftermarket control to replace the factory Fisher 9800 control. This has a round screw on plug with 14 holes but uses only 10 pins. This is used on The Fisher EZ V plow (also works on Western MVP V). Check your plug, it only fits the EZ-V not the Extreme V. NOTE: There is a modification required for this control to work that you can read below. It is a simple modification but it is not a Plug-N-Plow item. Detailed Installation Instructions (Click Here)
1 – Control
1 – Mount Clip
1 – Ground Lead
1 – Wire Cap
4 – Tie Wraps
& Installation Instructions (See Instructions 906 IN-000)
-Control plugs directly into your existing harness, NO adapter required, just Plug-N-Plow
-Please make sure the connector matches your connector before ordering
-4 way (for Straight Blade Controllers) or 10 way (for Vee & Wing Blades) operation
-U-SET feature allows the user to change some of the controls features.
-Automatic Shut-off when not in use, approximately 22 minutes
-The plow blade will coast to a soft stop (left or right), results in smoother operation and decreased wear on the plows hydraulic system
-Express Up/Down Feature (Double Tap)
-On/Off switch can be used as an Emergency Stop when required
-Illuminated keypad on control for night time plowing
-All control functions will time out (shut-off) after a period of time. This helps reduce wear on the pump motor and prevent unnecessary battery drain. Time outs vary depending on which plow the control will be used for.
-Flexible Straight Cord
-Use for both Left or Right Hand
-Dash Mount Control Holder Included
-Instructions come with each control
-Designed and Manufactured in the U.S.A.
DISCLAIMER: The use of the names of manufacturers is for the assistance of our customers in identifying replacement parts which we manufacture or which may be manufactured for 906 Engineering Corp. It is not implied that any part listed is the product of these manufacturers.